LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Electronic Engine Controls - INGENIUM I4 2.0L Diesel -- Range Rover Velar/L560) >> Electronic Engine Controls - INGENIUM I4 2.0L Diesel >> Diagnosis And Testing >> Electronic Engine Controls - INGENIUM I4 2.0L Diesel (G1923233) >> Drive Cycle: Misfire Monitors >> Test Procedure

Test Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Using the Jaguar Land Rover approved diagnostic equipment, perform routine - OBD II Readiness Tests.
  2. Start the engine and run at idle speed for a minimum of 10 minutes.
  3. Using the Jaguar Land Rover approved diagnostic equipment, check the readiness status of the misfire monitor.
scientia non olet · About LEMON Manuals