LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Electronic Engine Controls - INGENIUM I4 2.0L Diesel -- Range Rover Velar/L560) >> Electronic Engine Controls - INGENIUM I4 2.0L Diesel >> Diagnosis And Testing >> Electronic Engine Controls - INGENIUM I4 2.0L Diesel (G1923233) >> Drive Cycle: Boost Pressure Monitors >> Test Procedure

Test Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Using the Jaguar Land Rover approved diagnostic equipment, perform routine - OBD II Readiness Tests.
  2. Start the engine.
  3. Drive the vehicle steadily at a speed of approximately 50 mph (80 km/h) for a minimum of 10 minutes.
  4. Using the Jaguar Land Rover approved diagnostic equipment, check the readiness status of the boost pressure monitors.
scientia non olet · About LEMON Manuals