Symptom Chart
WARNING: This page is about a different variant/trim than selected.
| SYMPTOM |
POSSIBLE CAUSES |
ACTION |
| Engine malfunction lamp illuminated |
- Selective catalyst reduction system failure
- Diesel exhaust fluid level too low
- Power or ground failure
- Diesel exhaust fluid pressure too low
- Diesel exhaust fluid pressure too high
- Diesel exhaust fluid injection pump
- Diesel exhaust fluid injector
- Diesel exhaust fluid relay
- Diesel exhaust fluid heater control unit
- Pre selective catalytic reduction NOx sensor
- Pre selective catalyst reduction NOx sensor module
- Post selective catalyst reduction NOx sensor
- Post selective catalyst reduction NOx sensor module
- Post selective catalyst reduction particulate matter sensor
- Post selective catalyst reduction particulate matter sensor
- Diesel sub net Controller Area Network (CAN) communication bus
|
- Using the Jaguar Land Rover approved diagnostic equipment run the guided diagnostic flow by selecting customer concern area - 'Warnings'/'Messages'/'Diesel Exhaust Fluid'
- Using the Jaguar Land Rover approved diagnostic equipment check the powertrain control module for related Diagnostic Trouble Code(s) and refer to relevant DTC index
- Check and correct the diesel exhaust fluid level
- Refer to the appropriate system wiring diagrams and check connections are secure and wiring integrity
- Refer to the repair information and the battery care information, inspect the vehicle battery and make sure it is fully charged and serviceable before performing further tests
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Refer to the appropriate system wiring diagrams and check sensor, relays/fuses and control module power feeds and grounds
- Check system for correct installation of components
- Check system mechanical and fluid integrity
- Check system for mechanical integrity
- Check system for leakage
- Check system for blockage
|
|
|
- Vehicle battery failure
- Diesel exhaust fluid level too low
- Harness failure - Wiring integrity
|
- Refer to the repair information and the battery care information, inspect the vehicle battery and make sure it is fully charged and serviceable before performing further tests
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Check and correct the diesel exhaust fluid level
- Using the Jaguar Land Rover Approved Diagnostic Equipment complete any required routines
|
|
|
- Selective catalyst reduction system failure
- A monitor of the historical diesel exhaust fluid consumption rate, allied with a direct reading of the diesel exhaust fluid level in the tank, predicts that the distance to emptying the tank is less than 2400km
|
- Using the Jaguar Land Rover Approved Diagnostic Equipment check the powertrain control module for related Diagnostic Trouble Code(s) and refer to relevant DTC index
- Check and correct the diesel exhaust fluid level
|