Hood Latch Panel (G2042263): Installation

WARNING: This page is about a different car, the 2019 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.

The following step(s) applies to:

All vehicles

Install the air cleaner mount bracket.
Torque : 10 Nm
NOTE: The step must be carried out on both sides.

Install the plastic inserts.
With assistance, install the hood latch panel.
Torque : 24 Nm
Secure the wiring harness.
Secure the coolant hose.
- Install the hood latches.
  Torque : 10 Nm
- Connect one electrical connector.
- Install the left air cleaner mount bracket.
  Torque : 10 Nm
- Secure the latch cable with the clip.
- Install the dirty air duct.
- Secure the hood latch cable with the clips.

The following step(s) applies to:

Vehicles with 3.0L engine

Install the air intake ducts.

The following step(s) applies to:

Vehicles with 2.0L engine

Install the air intake duct.
Install the left air intake duct.

The following step(s) applies to:

All vehicles

Install the headlamps.
Refer to: HEADLAMP ASSEMBLY