Fender (G2264542): Removal

WARNING: This page is about a different car, the 2019 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

NOTE: If equipped.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the screw.
- Remove the 2 clips.
- Remove the front mudflap.
Remove the front wheel arch liner.
Refer to: FENDER ALIGNMENT
Remove the headlamp.
Refer to: HEADLAMP ASSEMBLY
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Carefully release the 4 clips.
- Remove the front fender lower moulding.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 2 clips.
- Remove the baffle plate.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the nut.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the 2 bolts.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the 2 bolts.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 3 bolts.
- Remove the front fender.
NOTE: Only do the following step(s) if a new component is to be installed.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the 5 clips.
- Remove the front fender upper finisher.