Turbocharger Turbine Bypass Actuator Lubrication

NOTE: Do NOT  remove the turbocharger assembly from the vehicle to complete this process.

1. Remove the turbocharger heatshield(s) to gain access to the turbocharger turbine bypass actuator arm linkage and pins. Refer to: TURBOCHARGER  and follow steps for heatshield removal

NOTE:

• Jaguar Land Rover approved anti-squeak grease is required for this step.
• For Land Rover vehicles use part number - LR164809 - Do NOT use any other grease or lubricant.
• For Jaguar vehicles use part number - JDE41322 - Do NOT use any other grease or lubricant.
• Do NOT remove the turbocharger turbine bypass actuator arm linkage from the turbocharger to apply grease.

1. Refer to the images below and apply the Jaguar Land Rover approved anti-squeak grease to the turbocharger turbine bypass actuator arm linkage and pins as shown. A maximum of 2 drops of grease should be applied to each circlip hole

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

1. After applying the anti-squeak grease to the areas indicated, the turbocharger must be left for 2 minutes. This is to make sure the grease has full diffusion between the actuator arm linkage and pins
2. Actuate the turbocharger 3 times to make sure the grease is distributed adequately between the actuator arm linkage and pins
3. Re-install the turbocharger heatshield(s). Refer to: TURBOCHARGER  And follow steps for heatshield installation