Brake Booster - Left Hand Drive (G2135340): Removal
CAUTION:
- Brake fluid will damage paint finished surfaces. If spilled, immediately remove the fluid and clean the area with water.
- Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- Remove the left side secondary bulkhead panel.
Refer to: SECONDARY BULKHEAD LEFT PANEL - INGENIUM I4 2.0L DIESEL
Refer to: SECONDARY BULKHEAD LEFT PANEL - V6 S/C 3.0L PETROL
Refer to: SECONDARY BULKHEAD LEFT PANEL - TDV6 3.0L DIESEL
Refer to: SECONDARY BULKHEAD LEFT PANEL - INGENIUM I4 2.0L PETROL
- Remove the brake master cylinder.
Refer to: BRAKE MASTER CYLINDER
- Remove the 3 clips and lower the trim panel.
- Disconnect the electrical connector and remove the trim panel.
- Remove and discard the brake booster push rod retaining clip.
- Remove and discard the brake pedal mounting nuts.
- Release the brake pipes from the retaining clip and reposition away from the brake booster.
- Disconnect the brake booster vacuum pipe and reposition away from the brake booster.
- Remove the brake booster.