LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2017 >> Range Rover Autobiography >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Fuel Charging & Controls - V8 S/C 5.0L Petrol -- Range Rover/L405 >> Fuel Charging And Controls - V8 S/C 5.0L Petrol >> Throttle Body >> Removal And Installation >> Removal

Removal And Installation: Removal

NOTE: Removal steps in this procedure may contain installation details.
  1. Disconnect the battery ground cable.

    Refer to: SPECIFICATIONS .

  2. WARNING: Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  3. Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING .
  4. G11770628
  5. G11770629
  6. NOTE: This step should only be carried out on vehicles pre 2015.
    G11770630

    Renew Part: Engine coolant outlet seal Quantity: 1  .

    Torque Specification: 10 Nm 

  7. NOTE: This step should only be carried out on vehicles from 2015 onwards.
    G11770631

    Renew Part: Engine coolant outlet seal Quantity: 1  .

    Torque Specification: 10 Nm 

  8. G11770632
  9. G11770633

    Torque Specification: 10 Nm 

  10. CAUTION: Do not attempt to clean the throttle body bore, build up of deposits reduces air leakage past the throttle plate at the fully closed position.
    G11770634
    • Remove and discard the gasket.
    • Install a new gasket.

      Renew Part: Throttle body gasket Quantity: 1  .

    • Clean the components mating faces.
scientia non olet · About LEMON Manuals