LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2017 >> Range Rover Autobiography >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Parking Brake & Actuation -- Range Rover/L405 >> Parking Brake And Actuation >> Parking Brake Release Actuator >> Removal And Installation >> Removal

Removal And Installation: Removal

NOTE:
  • Removal steps in this procedure may contain installation details.
  • Some components shown removed for clarity.
  • Some variation in the illustrations may occur, but the essential information is always correct.
  1. Connect the diagnostic tool and set the electronic park brake (EPB) to the maintenance position.
  2. Disconnect the battery ground cable.

    Refer to: SPECIFICATIONS

  3. WARNING: Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  4. Remove the rear wheel and tire.

    Refer to: WHEEL AND TIRE - TDV6 3.0L DIESEL/TDV8 4.4L DIESEL/V6 S/C 3.0L PETROL/V8 N/A 5.0L PETROL/V8 S/C 5.0L PETROL

  5. G11692302
  6. NOTE: Remove and discard the retaining bolts and O-ring seal.
G11692303

Torque Specification: 11 Nm 

scientia non olet · About LEMON Manuals