LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2017 >> Discovery Sport SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Electronic Engine Controls - INGENIUM I4 2.0L Petrol -- Discovery Sport/L550) >> Electronic Engine Controls - INGENIUM I4 2.0L Petrol >> Diagnosis And Testing >> Electronic Engine Controls >> Symptom Chart

Symptom Chart

WARNING: This page is about a different car, the 2018 Land Rover Discovery Sport. However, it is still accessible from the selected car via links, so may be relevant.
SYMPTOM POSSIBLE CAUSES ACTION
The engine does not crank Battery/charging system fault
Engine system fault
Transmission fault
Transmission control switch not set to Park or Neutral
Smart key not present/recognized
Starter relay fault
Starter motor ground circuit open circuit, high resistance
Starter motor solenoid circuit short circuit to ground, open circuit, high resistance
Starter motor circuit short circuit to ground, open circuit, high resistance
Engine seized
Refer to the relevant section of the service information and check the battery and charging system. Rectify as necessary
Using the Jaguar Land Rover approved diagnostic equipment, check the powertrain control module for related DTCs and refer to the relevant DTC index
Using the Jaguar Land Rover approved diagnostic equipment, check the transmission control module for related DTCs and refer to the relevant DTC index
Set the transmission control switch to Park or Neutral and retest
Check that the smart key is present and recognized
Check the operation of the starter relay. Rectify as necessary
Refer to the appropriate system wiring diagram and check the starter motor ground circuit for open circuit, high resistance. Repair the wiring harness as necessary
Refer to the appropriate system wiring diagram and check the starter motor solenoid power circuit for short circuit to ground, open circuit, high resistance. Repair the wiring harness or install a new starter motor solenoid as necessary
Refer to the appropriate system wiring diagram and check the starter motor power circuit for short circuit to ground, open circuit, high resistance. Repair the wiring harness or install a new starter motor as necessary
Check that the engine turns freely
Engine cranks but does not start Positive crankcase ventilation system blocked/leaking
Ignition system fault
Fuel system fault
Engine system fault
Check the integrity of the positive crankcase ventilation system. Rectify as necessary
Refer to the relevant section of the service information and check the ignition system. Rectify as necessary
Refer to the relevant section of the service information and check the fuel system. Rectify as necessary
Using the Jaguar Land Rover approved diagnostic equipment, check the powertrain control module for related DTCs and refer to the relevant DTC index
Engine cranks and fires, but will not start Evaporative emissions system fault
Ignition system fault
Fuel system fault
Engine system fault
Refer to the relevant section of the service information and check the evaporative emissions system. Rectify as necessary
Refer to the relevant section of the service information and check the ignition system. Rectify as necessary
Refer to the relevant section of the service information and check the fuel system. Rectify as necessary
Using the Jaguar Land Rover approved diagnostic equipment, check the powertrain control module for related DTCs and refer to the relevant DTC index
Engine difficult to start (cold engine) Battery/charging system fault
Engine system fault
Fuel system fault
Evaporative emissions system fault
Refer to the relevant section of the service information and check the battery and charging system. Rectify as necessary
Using the Jaguar Land Rover approved diagnostic equipment, check the powertrain control module for related DTCs and refer to the relevant DTC index
Refer to the relevant section of the service information and check the fuel system. Rectify as necessary
Refer to the relevant section of the service information and check the evaporative emissions system. Rectify as necessary
Engine difficult to start (warm/hot engine) Injector(s) leaking
Engine system fault
Evaporative emissions system fault
Fuel system fault
Ignition system fault
Check the injectors for leaks. Rectify as necessary
Using the Jaguar Land Rover approved diagnostic equipment, check the powertrain control module for related DTCs and refer to the relevant DTC index
Refer to the relevant section of the service information and check the evaporative emissions system. Rectify as necessary
Refer to the relevant section of the service information and check the fuel system. Rectify as necessary
Refer to the relevant section of the service information and check the ignition system. Rectify as necessary
Engine difficult to start after hot soak (vehicle standing, engine off, after engine has reached operating temperature) Injector(s) leaking
Engine system fault
Evaporative emissions system fault
Fuel system fault
Ignition system fault
Check the injectors for leaks. Rectify as necessary
Using the Jaguar Land Rover approved diagnostic equipment, check the powertrain control module for related DTCs and refer to the relevant DTC index
Refer to the relevant section of the service information and check the evaporative emissions system. Rectify as necessary
Refer to the relevant section of the service information and check the fuel system. Rectify as necessary
Refer to the relevant section of the service information and check the ignition system. Rectify as necessary
Engine cranks too slowly Battery/charging system fault
Starter motor ground circuit open circuit, high resistance
Starter motor power circuit open circuit, high resistance
Starter motor internal failure
Engine oil grade incorrect
Refer to the relevant section of the service information and check the battery and charging system. Rectify as necessary
Refer to the appropriate system wiring diagram and check the starter motor ground circuit for open circuit, high resistance. Repair the wiring harness as necessary
Refer to the appropriate system wiring diagram and check the starter motor power circuit for open circuit, high resistance. Repair the wiring harness as necessary
Check the operation of the starter motor. Rectify as necessary
Check the engine oil grade. Rectify as necessary
Engine cranks too fast Timing chain failure
Low engine compression
Check the integrity of the timing chains. Rectify as necessary
Refer to the relevant section of the service information and test the engine cylinder compressions. Rectify as necessary
Engine stalls soon after start Positive crankcase ventilation system blocked/leaking
Engine system fault
Ignition system fault
Intake pipe restricted/blocked
Air filter element restricted/blocked
Intake pipe disconnected/damaged after the air cleaner
Fuel system fault
Check the integrity of the positive crankcase ventilation system. Rectify as necessary
Using the Jaguar Land Rover approved diagnostic equipment, check the powertrain control module for related DTCs and refer to the relevant DTC index
Refer to the relevant section of the service information and check the ignition system. Rectify as necessary
Check the intake pipe for restrictions and blockages. Rectify as necessary
Install a new air filter element as necessary
Check the intake system for correct installation and damage. Rectify as necessary
Refer to the relevant section of the service information and check the fuel system. Rectify as necessary
Engine stalls on overrun Engine system fault Using the Jaguar Land Rover approved diagnostic equipment, check the powertrain control module for related DTCs and refer to the relevant DTC index
Engine stalls at steady speed Engine system fault Using the Jaguar Land Rover approved diagnostic equipment, check the powertrain control module for related DTCs and refer to the relevant DTC index
Engine stalls with speed control enabled Engine system fault Using the Jaguar Land Rover approved diagnostic equipment, check the powertrain control module for related DTCs and refer to the relevant DTC index
Engine stalls when maneuvering Engine system fault
Excessive additional engine loads (power steering, air conditioning, etc)
Transmission fault
Using the Jaguar Land Rover approved diagnostic equipment, check the powertrain control module for related DTCs and refer to the relevant DTC index
Check for excessive loads being placed on the engine by the power steering, air conditioning, etc
Using the Jaguar Land Rover approved diagnostic equipment, check the transmission control module for related DTCs and refer to the relevant DTC index
Engine hesitates/poor acceleration Fuel system fault
Injector(s) leaking
Intake pipe disconnected/damaged after the air cleaner
Engine system fault
Accelerator pedal movement restricted (carpet, mats, etc)
Ignition system fault
Transmission fault
Refer to the relevant section of the service information and check the fuel system. Rectify as necessary
Check the injectors for leaks. Rectify as necessary
Check the intake system for correct installation and damage. Rectify as necessary
Using the Jaguar Land Rover approved diagnostic equipment, check the powertrain control module for related DTCs and refer to the relevant DTC index
Check that the accelerator pedal is free from restriction. Rectify as necessary
Refer to the relevant section of the service information and check the ignition system. Rectify as necessary
Using the Jaguar Land Rover approved diagnostic equipment, check the transmission control module for related DTCs and refer to the relevant DTC index
Engine backfires Fuel system fault
Intake pipe disconnected/damaged after the air cleaner
Engine system fault
Ignition system fault
Variable camshaft timing system stuck active
Refer to the relevant section of the service information and check the fuel system. Rectify as necessary
Check the intake system for correct installation and damage. Rectify as necessary
Using the Jaguar Land Rover approved diagnostic equipment, check the powertrain control module for related DTCs and refer to the relevant DTC index
Refer to the relevant section of the service information and check the ignition system. Rectify as necessary
Check the operation of the variable camshaft timing system. Rectify as necessary
Engine surges Fuel system fault
Engine system fault
Ignition system fault
Refer to the relevant section of the service information and check the fuel system. Rectify as necessary
Using the Jaguar Land Rover approved diagnostic equipment, check the powertrain control module for related DTCs and refer to the relevant DTC index
Refer to the relevant section of the service information and check the ignition system. Rectify as necessary
Engine detonates/knocks Engine system fault
Fuel system fault
Intake pipe disconnected/damaged after the air cleaner
Variable camshaft timing system stuck active
Using the Jaguar Land Rover approved diagnostic equipment, check the powertrain control module for related DTCs and refer to the relevant DTC index
Refer to the relevant section of the service information and check the fuel system. Rectify as necessary
Check the intake system for correct installation and damage. Rectify as necessary
Check the operation of the variable camshaft timing system. Rectify as necessary
No throttle response Engine system fault Using the Jaguar Land Rover approved diagnostic equipment, check the powertrain control module for related DTCs and refer to the relevant DTC index
Speed control inhibited/disabled Engine system fault Using the Jaguar Land Rover approved diagnostic equipment, check the powertrain control module for related DTCs and refer to the relevant DTC index
Throttle response poor Engine system fault
Positive crankcase ventilation system blocked/leaking
Transmission fault
Dynamic stability control event
Intake pipe disconnected/damaged after the air cleaner
Using the Jaguar Land Rover approved diagnostic equipment, check the powertrain control module for related DTCs and refer to the relevant DTC index
Check the integrity of the positive crankcase ventilation system. Rectify as necessary
Using the Jaguar Land Rover approved diagnostic equipment, check the transmission control module for related DTCs and refer to the relevant DTC index
No fault - Accelerator pedal response may be temporarily reduced or inhibited when the dynamic stability control is active
Check the intake system for correct installation and damage. Rectify as necessary
Malfunction indicator lamp illuminated or engine warning message displayed Engine system fault Using the Jaguar Land Rover approved diagnostic equipment, check the powertrain control module for related DTCs and refer to the relevant DTC index