Rear Section - Vehicles Without Spare Wheel

The rear section has a long pipe with a center silencer which is secured to the center section with a clamp. Two hanger bars, mounting rubbers and brackets forward and rearward of the center silencer secure the forward end of the pipe to the vehicle body.

The pipe is routed in a central position under the vehicle, with a slight deviation around the Rear Drive Unit (RDU), where it joins with the rear silencer. The rear silencer is supported by three rubber mountings; two are attached to mountings welded on the left side of the rear subframe and the third is attached to a bracket on the right side of the rear subframe.

The rear silencer has an outlet pipe at each end. Each pipe is fitted with a stainless steel finisher.