LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2017 >> Discovery Sport SE >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Drive Axle/Differential - Vehicles Without: Active Driveline -- Discovery Sport/L550 >> Rear Drive Axle/Differential - Vehicles Without: Active Driveline >> General Procedures >> Active On-Demand Coupling Filling

Active On-Demand Coupling Filling

NOTE:
  • If installing a new active on-demand coupling, fill with 780 ml of fluid. It is not possible to completely drain the active on-demand coupling fluid during service. The procedure below MUST be followed for both filling and topping up.
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. CAUTION: Make sure the vehicle is on a flat level surface.

    Raise and support the vehicle on a suitable 4 post lift.

    Refer to: LIFTING

  2. No provision is made to fully drain the active on-demand coupling. During repair procedures, fluid will be lost. A container should be positioned to collect any spillage.
  3. CAUTION: This is a filler plug only and must not be used as a fluid level indicator.
    G11716081

    Remove the active on-demand fluid filler plug.

  4. CAUTION: Care must be taken not to overfill the active on-demand coupling.

    Fill the active on-demand coupling with 780 ml of fluid.

    Refer to: SPECIFICATIONS 

  5. CAUTION: This is a filler plug only and must not be used as a fluid level indicator.
    G11716082

    Install the active on-demand fluid filler plug.

  6. Turn the ignition on for 5 minutes.
  7. Turn the ignition off.
scientia non olet · About LEMON Manuals