LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2017 >> Discovery Sport SE >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Drive Axle/Differential - Vehicles With: Active Driveline -- Discovery Sport/L550 >> Rear Drive Axle/Differential - Vehicles With: Active Driveline >> General Procedures >> Hydraulic System Fluid Level Check >> Check

Hydraulic System Fluid Level Check: Check

NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle.

    Refer to: LIFTING .

  2. Disconnect the startup battery ground cable.

    Refer to: SPECIFICATIONS .

  3. CAUTION: Make sure the battery is disconnected. Failure to follow this instruction will cause a Diagnostic Trouble Code (DTC) to be flagged on the vehicle.
    NOTE: The harness connector on the rear drive unit hydraulic motor has a two stage clip.
    G11716206

    Move the clip upwards as illustrated.

  4. G11716207

    Release the clip as illustrated to disconnect the electrical connector.

  5. G11716208

    Remove the fluid filler plug.

  6. CAUTION: Make sure the correct specification of oil is used.

    Fill the rear drive unit to the level of the of the fill plug.

    Refer to: SPECIFICATIONS .

  7. G11716208
    • Install the fluid filler plug.
    • Torque Specification: 12 Nm 
  8. Connect the rear drive unit hydraulic motor harness electrical connector.
  9. Connect the startup battery ground cable.

    Refer to: SPECIFICATIONS .

scientia non olet · About LEMON Manuals