Electric Park Brake Release When The Vehicle Has No Electrical Power: Part(S)
| STEP | PART NAME | QUANTITY |
|---|---|---|
| Adjustment Step 1 | Electric park brake actuator fitting kit | 2 |
CHECK
WARNING:
Chock the wheels and make sure that all personnel are clear of the vehicle before carrying out the following procedure.
NOTE:
- To be carried out in the event that the vehicle has no electrical power.
- This procedure must be completed to the components on both sides of the vehicle.
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- Raise and support the vehicle.
Refer to: JACKING
Refer to: LIFTING
- Remove the rear wheels and tires.
Refer to: WHEEL AND TIRE
Disconnect and release the wiring harness.
Remove and discard the parking brake actuators kits.
Using a suitable tool, rotate piston until the parking brake is released.
ADJUSTMENT
- Install the new parking brake actuators kits.
Renew Part: Electric park brake actuator fitting kit Quantity: 2 .
Torque Specification: 11 Nm
- Connect and secure the wiring harness.
- Install the rear wheels and tires.
Refer to: WHEEL AND TIRE
- Calibrate the electric parking brake (EPB) using the diagnostic tool.