Static Apply/Release

For the static apply to operate, the ignition can be on or off. When the EPB switch is pulled up, the ABS control module activates both EPB actuators to apply the brakes and signals the IC to turn on the park brake indicator lamp. The warning indicator remains on continuously while the ignition is on, and for 30 seconds after the ignition is switched off.

For the static release to operate the ignition must be on and either the brake, clutch or accelerator pedal pressed. When the EPB switch is pressed down, the ABS control module then activates both EPB actuators to release the brakes and signals the IC to turn off the park brake indicator lamp.