Parking Brake: Operation: Service

Functional Test 

The EPB incorporates a vehicle inspection mode that allows a functional test of the park brake to be performed on a rolling brake tester. For additional information, refer to: ELECTRIC PARK BRAKE SERVICE MODE ACTIVATION AND DEACTIVATION 

Brake Pad Replacement 

To change the rear brake pads it is necessary to fully retract the ball screw drive to allow retraction of the caliper piston. This can be done using one of the following methods: For additional information, refer to: ELECTRONIC PARKING BRAKE (EPB) SERVICE MODE ACTIVATION AND DEACTIVATION 

• Putting the ABS control module into the maintenance mode using Land Rover approved diagnostic equipment
• Putting the ABS control module into the maintenance mode without diagnostic equipment
• Remove the actuators from the calipers.