Rear Disc Brake: Specifications
GENERAL SPECIFICATION
| ITEM | SPECIFICATION | SPECIFICATION |
|---|---|---|
| - | 16" Brakes | 17" Brakes |
| Rear disc type | Solid | Vented |
| Rear disc diameter | 300mm (11.8 in) | 325mm (12.8 in) |
| Rear disc thickness new | 10mm (0.4 in) | 20mm (0.8 in) |
| Service limit | 8mm (0.31 in) | 18mm (0.71 in) |
| Maximum disc run out - disc installed | 0.070mm (0.0027 in) | 0.070mm (0.0027 in) |
| Pad minimum thickness | 2mm (0.078 in) | 2mm (0.078 in) |
| Piston diameter | 38mm (1.496 in) | 40mm (1.575 in) |
TORQUE SPECIFICATIONS
| DESCRIPTION | NM | LB-FT | ||
|---|---|---|---|---|
| Brake caliper bleed screw | 15 | 11 | ||
| Brake caliper carrier to suspension knuckle mounting bolts(1) | 110 | 81 | ||
| Brake caliper guide pin bolts | 28 | 21 | ||
| Brake disc Torx screw | 35 | 26 | ||
| Brake flexible hose union bolt to brake caliper | A** | A** | ||
| Brake pipe line union to flexible brake hose | 15 | 11 | ||
| Parking brake actuator to brake caliper bolt | 11 | 8 | ||
| Brake pad wear sensor | 28 | 21 | ||
A = Refer to procedure for correct torque sequence. |
||||