LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2016 >> Range Rover Supercharged >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension System - General Information -- Range Rover/L405 >> Suspension System - General Information >> Wheel Alignment >> General Procedures >> Activation

General Procedures: Activation

CAUTION:

Adjustments must completed on both sides of the vehicle.

NOTE:

Only use calibrated wheel alignment equipment recommended by Jaguar.

  1. Note the correct geometry values before completing this procedure. Refer to: SPECIFICATIONS 
    • Check the tie rod ends, suspension joints, wheel bearings and wheels and tires for damage, wear and excessive free play. Check and adjust the tire pressures.
    • Replace any excessively worn components before completing this procedure.
  3. Roll the vehicle backwards and forwards to settle the steering and suspension.
    • Position the vehicle on a flat and level surface.
    • Release the vehicle parking brake.

      Vehicles with air suspension

  5. Set the vehicle to air suspension manual tight tolerance setting mode. Refer to: AIR SUSPENSION MANUAL TIGHT TOLERANCE SETTING MODE

    All vehicles

  6. Install the recommended wheel alignment equipment.

    Rear wheel alignment

  7. G00570079

    Renew the rear toe link locking nuts. Renew Part: Toe link nut Quantity: 2.

  8. G00570080

    Adjust the rear wheel toe. Note the readings from the steering geometry test equipment and adjust the geometry as required.

    9. Fig 1:
    G00570080
  9. G00570079

    Tighten the rear toe link locking nuts. Torque specifications:

    • Stage 1: 40 Nm 
    • Stage 2:90° 

    Front wheel alignment

  10. CAUTION:

    To prevent damage to the tie rods, use an additional wrench when loosening or tightening the components.

    NOTE:

    Do not allow the steering gear boot to twist.

    G00570081

    Loosen the front tie rod locking nuts.

  11. G00570082

    Adjust the front wheel toe. Note the readings from the steering geometry test equipment and adjust the geometry as required.

  12. G00570081

    Tighten the front tie rod locking nuts. Torque specification: 76 Nm 

    Vehicles with air suspension 

  13. Set the vehicle to air suspension manual tight tolerance setting mode. Refer to: AIR SUSPENSION MANUAL TIGHT TOLERANCE SETTING MODE

    All vehicles 

  14. Install the recommended wheel alignment equipment.

    Rear wheel alignment 

  15. G00570079

    Renew the rear toe link locking nuts. Renew Part: Toe link nut Quantity: 2.

  16. G00570080

    Adjust the rear wheel toe. Note the readings from the steering geometry test equipment and adjust the geometry as required.

  17. G00570079

    Tighten the rear toe link locking nuts. Torque specifications:

    • Stage 1: 40 Nm 
    • Stage 2: 90° 

    Front wheel alignment 

  18. CAUTION:

    To prevent damage to the tie rods, use an additional wrench when loosening or tightening the components.

    NOTE:

    Do not allow the steering gear boot to twist.

    G00570081

    Loosen the front tie rod locking nuts.

  19. G00570082

    Adjust the front wheel toe. Note the readings from the steering geometry test equipment and adjust the geometry as required.

  20. G00570079

    Tighten the front tie rod locking nuts. Torque specification: 76 Nm 

scientia non olet · About LEMON Manuals