Inspection And Verification
WARNING:
Before carrying out a road test, make sure the vehicle is safe to do so. Failure to follow this instruction may result in personal injury
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT
acceptable. Substitution of control modules does not guarantee confirmation of a fault and may also cause additional faults in the vehicle being checked and/or the donor vehicle
NOTE:
Check and rectify basic faults before beginning diagnostic routines involving pinpoint tests
- Gather as much information from the driver as possible and verify the customer concern by carrying out a road test, as closely as possible reproducing the conditions under which the fault occurs
- Visually inspect for obvious signs of mechanical damage
VISUAL INSPECTION CHART
MECHANICAL - Tire pressures
- Damaged wheels or tires
- Wheel bearing(s)
- Loose or damaged front or rear suspension components
- Loose, damaged or missing suspension fastener(s)
- Damaged or leaking air suspension components
- Worn or damaged suspension bushing(s)
- Loose, worn or damaged steering system components
- Damaged axle components
- Damaged chassis
- If an obvious cause for an observed or reported condition is found, correct the cause (if possible) before proceeding to the symptom chart
- If the cause is not visually evident, verify the symptom and refer to the symptom chart, alternatively check for diagnostic trouble codes (DTCs) and refer to the DTC index