LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2016 >> Range Rover Supercharged >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension System - General Information -- Range Rover/L405 >> Suspension System - General Information >> Four Wheel Alignment >> General Procedures >> Preliminary

General Procedures: Preliminary

NOTE:
  • The vehicle must be set to tight tolerance mode before taking any geometry readings or making any geometry adjustments. 
  • Only use calibrated equipment recommended by Land Rover.
  • A change in camber means a change in toe, therefore camber must always be adjusted first (only where adjustable).
  1. Note the correct geometry values before carrying out this procedure. For additional information, refer to: SPECIFICATIONS 
  2. Check the tie rod ends, suspension joints, wheel bearings and wheels and tires for damage, wear and free play. Check and adjust the tire pressures.
  3. Roll the vehicle backwards and forwards to settle the steering and suspension.
  4. Set the vehicle into tight tolerance mode.

    For additional information, refer to: AIR SUSPENSION MANUAL TIGHT TOLERANCE SETTING MODE

scientia non olet · About LEMON Manuals