DTC P06DA-13: Engine Oil Pressure Control Circuit/Open - Circuit open: Action
WARNING: This page is about a different variant/trim than selected.
- Refer to the appropriate system wiring diagram and check the electric oil pump solenoid circuit for open circuit, high resistance
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Check and install a new electric oil pump solenoid as required
- Only if an oil change occurs before or after repair. Using the Jaguar Land Rover approved diagnostic equipment, carry out 'Oil service counter reset' routine (0x4024)
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest