Possible Causes
WARNING: This page is about a different variant/trim than selected.
NOTE:
To monitor glow plug and glow plug wiring harness. Glow plug control module internal logic
- Electrical Cause
- Yes
- Mechanical Cause
- Yes
- Control module cavity
- TDV8 Circuit reference I_T_GLW2
- Circuit reference O_T_GLW
- Circuit reference I_T_GLW1
- The powertrain control module has measured a resistance outside the expected range but not identified as too high or too low
- Glow plug circuit open circuit, high resistance
- Glow plug control module connector is disconnected, connector pin is backed out, connector pin corrosion
- Glow plug failure
- Glow plug control module failure