Possible Causes
WARNING: This page is about a different variant/trim than selected.
NOTE:
To monitor glow plug and glow plug wiring harness. Glow plug control module output terminal is open circuit or short circuit to power
- Electrical Cause
- Yes
- Mechanical Cause
- Yes
- Control module cavity
- TDV8 Circuit reference I_T_GLW2
- Circuit reference O_T_GLW
- Circuit reference I_T_GLW1
- The powertrain control module has received an indication about the component that indicates a failure e.g. an intelligent actuator or sensor is indicating an internal fault
- Glow plug circuit open circuit, high resistance
- Glow plug control module connector is disconnected, connector pin is backed out, connector pin corrosion
- Glow plug failure