Possible Causes
WARNING: This page is about a different variant/trim than selected.
- Purpose of the DTC
- Powertrain control module internal temperature sensor, plausibility check
- Electrical Cause
- Yes
- Mechanical Cause
- No
- Control module cavity
- Not applicable
- Monitor Description
- Sensors reports plausibility fault after software reset via software
- Prioritised List of Possible Causes
- The powertrain control module detected plausibility failures
- Other related DTCs
- Harness failure - Wiring integrity short circuit to ground, short circuit to power, open circuit, high resistance
- Powertrain control module internal temperature sensor failure