Possible Causes
WARNING: This page is about a different variant/trim than selected.
- Purpose of the DTC
- Monitoring of fuel injector system bank short circuit on bank 2
- Electrical Cause
- Yes
- Mechanical Cause
- Yes
- Control module cavity
- Not applicable
- Monitor Description
- If the high side current from the power stage is above a threshold the DTC will be set
- Prioritised List of Possible Causes
- The powertrain control module has detected a ground measurement for a period longer than expected or has detected a ground measurement when another value was expected
- All fuel injector(s) circuit short circuit to ground, open circuit, high resistance
- Connector is disconnected, connector pin is backed out, connector pin corrosion
- Harness failure - Wiring integrity all fuel injector(s) circuit short circuit to power, open circuit, high resistance
- Other electronic engine control related DTCs
- Powertrain control module power and ground circuits open circuit, high resistance
- Corrupt powertrain control module software
- Powertrain control module failure