DTC P062E-11: Fuel Injector Driver Circuit Performance Bank 2 - Circuit short to ground: Action
WARNING: This page is about a different variant/trim than selected.
- Vehicle Conditions to enable DTC Logging strategy
- Engine running
- Prioritised Checks to Perform
- Refer to the appropriate system wiring diagram and check all fuel injector(s) circuit for short circuit to ground, open circuit, high resistance
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Check and install a new harness as required
- Check powertrain control module for electronic engine control related DTCs and refer to relevant DTC index
- Refer to the appropriate system wiring diagram and check powertrain control module power and ground circuits for open circuit, high resistance
- Using the Jaguar Land Rover approved diagnostic equipment, re-configure the powertrain control module with the latest level software
- Check and install a new powertrain control module, only when diagnosed as failed
- Using the Jaguar Land Rover approved diagnostic equipment, carry out 'New Module - Powertrain control module - Diesel' routine
- Using the Jaguar Land Rover approved diagnostic equipment, carry out 'Fuel lift pump' routine (0x4027_00)
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest