Possible Causes
WARNING: This page is about a different variant/trim than selected.
NOTE:
To diagnose an open load condition in the starter motor relay circuits
- Electrical Cause
- Yes
- Mechanical Cause
- Yes
- Control module cavity
- Circuit reference O_S_STRTH
- Circuit reference O_S_STRTL1
- The powertrain control module has determined an open circuit via lack of bias voltage, low current flow, no change in the state of an input in response to an output
- Starter motor relay circuit short circuit open circuit, high resistance
- Connector is disconnected, connector pin is backed out, connector pin corrosion
- Starter motor relay failure