Possible Causes
WARNING: This page is about a different variant/trim than selected.
- Purpose of the DTC
- Powertrain control module internal level 2 monitoring
- Electrical Cause
- Yes
- Mechanical Cause
- Yes
- Control module cavity
- Not applicable
- Monitor Description
- Difference between the two accelerator pedal values are compared with threshold and are not equal to threshold
- Prioritised List of Possible Causes
- The value of the signal measured by the powertrain control module is not plausible given the operating conditions
- Powertrain control module connector is disconnected, connector pin is backed out, connector pin corrosion
- Powertrain control module power and ground circuits open circuit, high resistance
- Powertrain control module mechanical integrity