DTC P060D-29: Internal Control Module Accelerator Pedal Position Performance - Signal invalid: Action
WARNING: This page is about a different variant/trim than selected.
- Vehicle Conditions to enable DTC Logging strategy
- Ignition On
- Prioritised Checks to Perform
- Using the Jaguar Land Rover approved diagnostic equipment, check and install latest relevant level of software to the powertrain control module
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Refer to the appropriate system wiring diagram and check powertrain control module power and ground circuits for open circuit, high resistance
- Check powertrain control module for mechanical integrity
- Check and install a new powertrain control module, only when diagnosed as failed
- Using the Jaguar Land Rover approved diagnostic equipment, carry out 'New Module - Powertrain control module - Diesel' routine
- Using the Jaguar Land Rover approved diagnostic equipment, carry out 'Fuel lift pump' routine (0x4027_00)
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest