Possible Causes
WARNING: This page is about a different variant/trim than selected.
- Purpose of the DTC
- Powertrain control module internal level 2 monitoring
- Electrical Cause
- Yes
- Mechanical Cause
- No
- Control module cavity
- Not applicable
- Monitor Description
- Error occurs during the powertrain control module internal shut-off path test
- Prioritised List of Possible Causes
- The value of the signal measured by the powertrain control module is not plausible given the operating conditions
- Powertrain control module software calibration error
- Powertrain control module power and ground circuits open circuit, high resistance