Possible Causes
WARNING: This page is about a different variant/trim than selected.
- Electrical Cause
- Yes
- Mechanical Cause
- Yes
- Control module cavity
- Circuit reference I_A_EGR2
- Circuit reference O_T_EGRPO S2
- Circuit reference O _T_EGRNEG2
- The powertrain control module has not detected any motion, upon commanding the operation of a motor, solenoid or relay to close some piece of equipment
- Low pressure EGR valve mechanical integrity
- Low pressure EGR valve circuit short circuit to ground, short circuit to power, open circuit, high resistance
- Connector is disconnected, connector pin is backed out, connector pin corrosion
- Low pressure EGR valve failure