DTC P0340-31: Camshaft Position Sensor "A" Circuit Bank 1 or Single Sensor - No signal: Action
WARNING: This page is about a different variant/trim than selected.
- Vehicle Conditions to enable DTC Logging strategy
- Engine speed greater than 400 RPM
- Prioritised Checks to Perform
- Refer to the appropriate system wiring diagram and check the camshaft position sensor circuit for short circuit to ground, short circuit to power, open circuit, high resistance
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Check the sensor and camshaft target for damage, contamination, and correct mounting. Check camshaft timing is to specification
- Check and install a new camshaft position sensor as required
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest