Possible Causes
WARNING: This page is about a different variant/trim than selected.
- Purpose of the DTC
- To monitor the active engine mounts circuit
- Electrical Cause
- Yes
- Mechanical Cause
- Yes
- Control Module Cavity
- Circuit reference O_T_EMC1
- Monitor Description
- Open load on active engine mount circuit
- The powertrain control module has determined an open circuit via lack of bias voltage, low current flow, no change in the state of an input in response to an output
- Engine mount - Active, - left/right circuit short circuit to ground, open circuit, high resistance
- Connector is disconnected, connector pin is backed out, connector pin corrosion
- Engine mount - Active, - left/right failure