Possible Causes
WARNING: This page is about a different variant/trim than selected.
NOTE:
To indicate that the starter motor is too hot and is overloaded
- Electrical Cause
- Yes
- Mechanical Cause
- Yes
- Control module cavity
- Circuit reference O_S_STRTH
- Circuit reference O_S_STRTL1
- The powertrain control module has not detected any motion, in response to energizing a motor, solenoid or relay
- Powertrain control module has logged an extended crank with no engine start
- Other related DTCs
- Harness failure - Starter motor circuit and relays circuit short circuit to ground, short circuit to power, open circuit, high resistance
- Vehicle battery failure
- Starter motor jammed
- Starter motor mechanical failure