Removal And Installation: Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
Removal steps in this procedure may contain installation details.
- Disconnect the battery ground cable.
Refer to: SPECIFICATIONS
- Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING
-
NOTE: Note the fitted position of the accessory drive belt.
- Using a suitable 6mm bar, retain the coolant pump pulley.
- Torque Specification: 25 Nm
Torque Specification: 10 Nm
-
CAUTION: A new O-ring seal is to be installed.