Removal And Installation: Removal

WARNING: This page is about a different variant/trim than selected.

CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.

NOTE: Some variation in the illustrations may occur, but the essential information is always correct.

Disconnect the battery ground cable.
Refer to: SPECIFICATIONS
Drain the engine oil.
Remove the EGR valve.
Refer to: RIGHT EXHAUST GAS RECIRCULATION VALVE
Remove the starter motor.
Refer to: STARTER MOTOR
Cut the exhaust in the position illustrated.

Special Tool(s): 100-051
Remove the exhaust gas temperature sensor.
Remove the bolts.
- Remove the exhaust down pipe.
- Remove and discard the gasket.
CAUTION: Be prepared to collect escaping oil.

NOTE: Discard the seal.

Remove the turbocharger oil return pipe.
Remove the Exhaust heatshield.
Remove the exhaust manifold heatshield.
Disconnect the harness.
Remove the vacuum pipe.
CAUTION: Be prepared to collect escaping oil.

Remove the banjo bolt.
Remove the clip.
Remove the charge air duct.
Remove the intake air duct.
Remove the bracket.
NOTE: Discard the gasket.
- Remove the bolts.
- Remove the turbocharger.