ECO System Inhibits
WARNING: This page is about a different variant/trim than selected.
The inhibit conditions listed below will not set Diagnostic Trouble Codes (DTCs) but will set flags which can be viewed using the manufacturer approved diagnostic system - Datalogger/Engine Control Module (ECM). Normal ECO system operation will resume when an inhibit condition is no longer present, but the battery related inhibits may persist for some time.
NOTE:
Do not reset the Battery Monitoring System (BMS) to rectify battery condition inhibits. This may temporarily restore ECO system operation but will lead to a recurrence of the fault.
| INHIBITS |
- ECO switch has been pressed by driver
- Transmission not in neutral
- Clutch pedal not fully released
- Accelerator pedal not released
- Hood open detected
- Driver door detected open
- Driver seatbelt not fastened
- Hill Descent Control (HDC) is switched on
- Terrain response special program selected
- Climate control demand exceeds calibrated threshold
- Heated windshield operating
- Trailer connected
- Brake booster vacuum below threshold
- Engine coolant temperature below threshold
- Engine oil temperature below threshold
- Catalytic converter outside either pre or post calibration range
- Diesel Particulate Filter (DPF) active regeneration in progress (diesel engines only)
- Battery state of charge low
- Battery cold cranking capability below threshold
- Ambient temperature above 40°C
- Ambient temperature below 0°C
|