Removal And Installation: Installation
- CAUTION: Make sure that a new component is installed.
Renew Part: Fuel rail RH supply pipe Quantity: 1 .
- CAUTION: Only tighten the unions finger-tight at this stage.
Renew Part: Fuel rail balance pipe Quantity: 1 .
Torque Specification: 9 Nm
-
CAUTION: Only tighten the bolts finger-tight at this stage.
-
CAUTION: Only tighten the unions finger-tight at this stage.
- CAUTION: Make sure that new components are installed.
Renew Part: Fuel injector high pressure pipe(s) Quantity: 1 .
Torque Specification: 9 Nm
Torque Specification: 24 Nm
-
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
- Stage 1:Tighten the high-pressure fuel supply line unions at the fuel rail to 15Nm.
- Stage 2: Tighten the high-pressure fuel supply line unions at the injector to 15Nm.
-
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
- Stage 1: Tighten the high-pressure fuel supply line unions at the fuel rail to 35Nm.
- Stage 2: Tighten the high-pressure fuel supply line unions at the injector to 35Nm.
Tighten the high-pressure fuel lines union to 15Nm.
Tighten the high-pressure fuel lines union to 15Nm.
Tighten the high-pressure fuel lines union to 35Nm.
Tighten the high-pressure fuel lines union to 35Nm.
Tighten the high-pressure fuel lines union to 15Nm.
Tighten the high-pressure fuel lines union to 15Nm.
Tighten the high-pressure fuel line union to 35 Nm.
Tighten the high-pressure fuel line union to 35 Nm.
Torque Specification: 10 Nm
Torque Specification: 10 Nm
Torque Specification: 10 Nm
Torque Specification: 10 Nm
- Refer to: RIGHT EXHAUST GAS RECIRCULATION VALVE OUTLET TUBE
-
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING
- Refer to: SECONDARY BULKHEAD CENTER PANEL - TDV6 3.0L DIESEL
- Refer to: SPECIFICATIONS