Removal And Installation: Installation
- CAUTION: Make sure that a new component is installed.
Renew Part: Fuel rail balance pipe Quantity: 1 .
-
CAUTION: Only tighten the bolts finger-tight at this stage.
- CAUTION: Make sure that a new component is installed.
Renew Part: Fuel rail LH supply pipe Quantity: 1 .
-
CAUTION: Tighten the retaining bolt finger tight.
-
CAUTION: Only tighten the bolts finger-tight at this stage.
-
CAUTION: Tighten the fuel supply line unions finger tight.
-
CAUTION: Tighten the fuel supply line unions finger tight.
- CAUTION: Make sure that a new component is installed.
Renew Part: Fuel injector high pressure pipe(s) Quantity: 3 .
-
CAUTION: Tighten the fuel supply line clamp bolt finger tight.
Torque Specifications:
Fuel supply line unions to fuel rail 15 Nm
Fuel supply line unions to fuel injectors 15 Nm
Torque Specification: 15 Nm
Torque Specification: 15 Nm
Torque Specification: 15 Nm
Torque Specification: 15 Nm
Torque Specifications:
Fuel supply line unions to fuel rail 35 Nm
Fuel supply line unions to fuel injectors 35 Nm
Torque Specification: 35 Nm
Torque Specification: 35 Nm
Torque Specification: 35 Nm
Torque Specification: 10 Nm
Torque Specification: 10 Nm
Torque Specification: 10 Nm
Torque Specification: 10 Nm
-
NOTE: Make sure that the fuel injector return line has a maximum of 8 uses.
Torque Specification: 10 Nm
Torque Specification: 10 Nm
- Refer to: LEFT EXHAUST GAS RECIRCULATION VALVE - TDV6 3.0L DIESEL - GEN 2
- Refer to: LEFT EXHAUST GAS RECIRCULATION VALVE OUTLET TUBE
- Refer to: COOLING SYSTEM DRAINING AND VACUUM FILLING
- Refer to: SECONDARY BULKHEAD CENTER PANEL - TDV6 3.0L DIESEL
- Connect the startup battery ground cable.