Removal And Installation: Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: This step is only required if previously removed.
CAUTION: Make sure that new sealing washers are installed.

NOTE: This step is only required if previously removed.

Renew Part: Fuel injector seals Quantity: 1 .

Renew Part: Fuel injector washer(s) Quantity: 1 .
CAUTION: Make sure that the area around the open fuel injector ports are clean and free of foreign material and lubricant prior to installing the fuel injector.
NOTE: Tighten the retaining bolts evenly and progressively.

Torque Specification: 9 Nm
CAUTION: Make sure that a new component is installed.

Renew Part: Fuel injector high pressure pipe(s) Quantity: 1 .
- Stage 1:Tighten the high-pressure fuel supply line unions at the fuel rail to 15Nm.
- Stage 2: Tighten the high-pressure fuel supply line unions at the injector to 15Nm.
- Stage 1: Tighten the high-pressure fuel supply line unions at the fuel rail to 35Nm.
- Stage 2: Tighten the high-pressure fuel supply line unions at the injector to 35Nm.
Torque Specification: 10 Nm
NOTE: Make sure that the fuel injector return line has a maximum of 8 uses.
Torque Specification: 10 Nm
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING
Refer to: SECONDARY BULKHEAD CENTER PANEL - TDV6 3.0L DIESEL
Refer to: SPECIFICATIONS
If a new unit is installed, configure using the approved diagnostic tool.