Removal And Installation: Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
Removal steps in this procedure may contain installation details.
- Refer to: FUEL INJECTION COMPONENT CLEANING
- Refer to: REAR END ACCESSORY DRIVE
- Refer to: CRANKCASE VENT OIL SEPARATOR
-
CAUTION: Be prepared to collect escaping fuel.
-
CAUTION: Be prepared to collect escaping fuel.
-
CAUTION: Be prepared to collect escaping fuel.
-
CAUTION: Be prepared to collect escaping fuel.
-
CAUTION: Be prepared to collect escaping fuel.NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
-
CAUTION: Be prepared to collect escaping fuel.NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
-
CAUTION: Be prepared to collect escaping fuel.
-
NOTE: Fuel injection pump pulley shown removed for clarity.
-
NOTE: Fuel injection pump pulley shown removed for clarity.
-
NOTE: If equipped.
-
NOTE: If equipped.
Special Tool(s): JLR-303-1523
Special Tool(s): JLR-303-1523
Remove the camshaft rear pulley retaining bolt.
Special Tool(s): 303-1145/2
- Remove the special tools.
-
NOTE: Do not disassemble further if the component is removed for access only.
Special Tool(s): 310-139A
Special Tool(s): 310-138A