Removal And Installation: Installation
Special Tool(s): 310-139A
Torque Specification: 50 Nm
Torque Specification: 3 Nm
Torque Specification: 23 Nm
Torque Specification: 10 Nm
-
CAUTION: Apply loctite 242 to the new camshaft pulley bolt.
Special Tool(s): JLR-303-1523
Torque Specification: 10 Nm
Special Tool(s): JLR-303-1523
-
CAUTION: Make sure the torque wrench setting procedure is followed correctly. Failure to follow this instruction may result in damage to the vehicle.
- Calculate the setting for the torque wrench:
- Stage 1: Multiply the required torque by the effective length of the torque wrench (1).
- Stage 2: Add the effective length of the special tool (2) to the effective length of the torque wrench.
- Stage 3: Divide the total of stage 1 by the total of stage 2.
- Stage 4: Set the torque wrench to the figure arrived at in stage 3.
-
CAUTION: Make sure the torque wrench setting procedure is followed correctly. Failure to follow this instruction may result in damage to the vehicle.
Special Tool(s): 303-1145/2
Torque Specifications:
Stage 1: 80 Nm
Stage 2: 80°
- Remove the special tools.
-
NOTE: If equipped.
Torque Specification: 10 Nm
-
NOTE: If equipped.
Torque Specification: 10 Nm
-
NOTE: Fuel injection pump pulley shown removed for clarity.
Torque Specification: 10 Nm
-
NOTE: Fuel injection pump pulley shown removed for clarity.
Torque Specification: 23 Nm
- CAUTION: Tighten the fuel supply line unions finger tight.
Renew Part: Fuel rail LH supply pipe Quantity: 1 .
Renew Part: Fuel rail RH supply pipe Quantity: 1 .
-
CAUTION: Tighten the fuel supply line unions finger tight.NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
-
CAUTION: Tighten the fuel supply line unions finger tight.NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
- CAUTION: Make sure that a new component is installed.
Renew Part: Fuel rail balance pipe Quantity: 1 .
- CAUTION: Tighten the fuel supply line unions finger tight.
Renew Part: Fuel rail supply pipe(s) Quantity: 1 .
Torque Specification: 10 Nm
Tighten the high-pressure fuel lines union to 15Nm.
-
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
Tighten the high-pressure fuel lines union to 15Nm.
-
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
Tighten the high-pressure fuel line union to 15 Nm.
Tighten the high-pressure fuel lines union to 15Nm.
Tighten the high-pressure fuel lines union to 15Nm.
Tighten the high-pressure fuel line union to 35 Nm.
-
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
Tighten the high-pressure fuel line union to 35 Nm.
-
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
Tighten the high-pressure fuel line union to 35 Nm.
Tighten the high-pressure fuel line union to 35 Nm.
Tighten the high-pressure fuel line union to 35 Nm.
Torque Specification: 10 Nm
- Refer to: CRANKCASE VENT OIL SEPARATOR
- Refer to: REAR END ACCESSORY DRIVE
- Refer to: HIGH-PRESSURE FUEL SYSTEM BLEEDING