LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2016 >> Range Rover Supercharged >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Electronic Engine Controls - TDV6 3.0L Diesel -- Range Rover/L405) >> Electronic Engine Controls - TDV6 3.0L Diesel >> Pre Catalytic Converter Temperature Sensor >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. CAUTION:
    • If accidentally dropped or knocked install a new sensor.
    • Make sure that the mating face is clean and free of foreign material.
    NOTE: If the original sensor is to be installed, apply lubricant meeting specification ESE-M12A4-A to the thread of the sensor.
    G11772175

    Torque Specification: 35 Nm 

  2. G11772174
  3. Install the front driveshaft.

    Refer to: FRONT DRIVESHAFT - TDV6 3.0L DIESEL

scientia non olet · About LEMON Manuals