LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2016 >> Range Rover Supercharged >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Electronic Engine Controls - TDV6 3.0L Diesel -- Range Rover/L405) >> Electronic Engine Controls - TDV6 3.0L Diesel >> Crankshaft Position Sensor Ring >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. CAUTION: Make sure that the CKP sensor ring is aligned correctly with the special tool pip and that both mating surfaces are fully seated.
    NOTE: Make sure a new CKP sensor ring is installed.
    G11608492

    Special Tool(s): 303-1130 

    Replace Part: Crank position sensor ring (CKP)  Quantity: 1  .

  2. G11608493

    Install the special tool.

  3. G11608494
  4. G11608495
  5. G11608493

    Remove the special tool.

    Special Tool(s): 303-1130 

  6. CAUTION: Install the CKP sensor correctly into the housing. Failure to follow this instruction may result in damage to the CKP sensor.
    G11608490
    • Torque Specification: 5 Nm 

  7. FLEXPLATE

  8. Connect the battery ground cable.

    Refer to: SPECIFICATIONS

scientia non olet · About LEMON Manuals