Removal And Installation: Removal
WARNING: This page is about a different variant/trim than selected.
- Disconnect the battery ground cable.
Refer to: SPECIFICATIONS
- Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING
- Refer to: SECONDARY BULKHEAD CENTER PANEL - TDV6 3.0L DIESEL
- Refer to: ACCESSORY DRIVE BELT IDLER PULLEY
Torque Specification: 3 Nm
Torque Specification: 8 Nm
Torque Specification: 8 Nm
Torque Specification: 8 Nm
Torque Specification: 8 Nm
Torque Specification: 8 Nm
CAUTION: Discard the bolts.- Using a suitable 6mm bar, retain the coolant pump pulley.
- Renew Part: Engine coolant pump pulley bolts Quantity: 1
.
Torque Specification: 25 Nm
Torque Specification: 25 Nm
Torque Specification: 10 Nm