Removal And Installation: Installation

WARNING: This page is about a different variant/trim than selected.

Renew Part: Timing belt Quantity: 1 .
CAUTION: Make sure that a new bolt is installed.

Renew Part: Timing belt tensioner Quantity: 1 .

Renew Part: Timing belt tensioner bolt Quantity: 1 .
CAUTION: Make sure the camshaft pulleys remain in the clockwise position.
- Install the new timing belt.
- Starting at the crankshaft pulley, install the timing belt in a counter-clockwise direction, in the sequence shown.
- Stage one: Attach the timing belt to the crankshaft pulley.
- Stage two: Attach the timing belt to the idler pulley.
- Stage three: Attach the timing belt to the left-hand camshaft pulley.
- Stage four: Attach the timing belt to the idler pulley.
- Stage five: Attach the timing belt to the RH camshaft pulley.
- Stage six: Attach the timing belt to the timing belt tensioner.
CAUTION: Make sure the timing belt tensioner window is aligned with the groove as illustrated.
- Tension the timing belt.
- Rotate the tensioner assembly counter-clockwise.
- Torque Specifications:
  Stage 1: 10 Nm
  
  Stage 2: 65°
CAUTION: Do not use the special tools to lock the camshafts. Failure to follow this instruction may result in damage to the engine or the special tools.
- Using a suitable tool, counterhold the camshaft pulley center retaining bolts.
- Torque Specification: 23 Nm
Special Tool(s): 303-1126
Special Tool(s): 303-1117
CAUTION: Only rotate the crankshaft clockwise.

Rotate the engine two complete turns clockwise.
Special Tool(s): 303-1117
- Install the special tools to the exhaust camshaft pulleys.
- If the special tool does not fit correctly, repeat the timing belt installation procedure.
- Remove the special tools from the camshaft pulleys.
Special Tool(s): 303-1117
Refer to: STARTER MOTOR
Refer to: TIMING COVER
Refer to: TIMING COVER - TDV6 3.0L DIESEL - GEN 2