Removal And Installation: Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
Removal steps in this procedure may contain installation details.
- Disconnect the battery ground cable
Refer to: SPECIFICATIONS
- Raise and support the vehicle.
- Refer to: TIMING COVER
- Refer to: RIGHT FUEL RAIL
- Refer to: INTAKE AIR SHUTOFF THROTTLE
- Refer to: FUEL INJECTION COMPONENT CLEANING
-
CAUTION: Be prepared to collect escaping fuel.
Install the special tool.
Special Tool(s): 100-012 , 310-213
Special Tool(s): 100-012 , 310-213
Remove the special tool.
Special Tool(s): 100-012 , 310-213
- Remove the 2 remaining fuel injectors.
-
NOTE: This step is only required if new components have not been installed.
-
NOTE: This step is only required if new components have not been installed.
- CAUTION: Make sure that the mating faces are clean and free of corrosion and foreign material.
-
NOTE: Discard the gasket.