LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2016 >> Range Rover Supercharged >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine - TDV6 3.0L Diesel - Gen 2/TDV6 3.0L Diesel -- Range Rover/L405) >> Engine - TDV6 3.0L Diesel - Gen 2/TDV6 3.0L Diesel >> Right Valve Cover >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION: Make sure that the mating faces are clean and free of corrosion and foreign material.
NOTE: Install a new gasket.
  1. G11695893

    Renew Part: Camshaft cover gasket Quantity: 1  .

    Torque Specification: 10 Nm 

  2. G11695892

    Torque Specification: 24 Nm 

  3. G11695891
  4. G11695890

    Torque Specification: 9 Nm 

  5. G11695889

    Torque Specification: 9 Nm 

  6. G11695888
  7. G11695887
  8. G11695885
  9. G11695886
  10. G11695884
    NOTE: This step is only required if previously removed.
  11. G11695904
    CAUTION: Make sure that new sealing washers are installed.
    NOTE: This step is only required if new components are not installed.
  12. G11695882

    Renew Part: Fuel injector washer(s) Quantity: 1  .

    Renew Part: Fuel injector O-ring seals Quantity: 1  .

    CAUTION: Make sure that the area around the open fuel injector ports are clean and free of foreign material and lubricant prior to installing the fuel injector.
    NOTE: Tighten the retaining bolts evenly and progressively.
  13. G11695878

    Torque Specification: 9 Nm 

  14. CAUTION: Be prepared to collect escaping fuel.
    NOTE: Make sure that the fuel injector return line has a maximum of 8 uses.
    G11695877
  15. Install the 2 remaining fuel injectors.
  16. G11695876
  17. Refer to: INTAKE AIR SHUTOFF THROTTLE
  18. Refer to: RIGHT FUEL RAIL
  19. Refer to: TIMING BELT 
  20. Connect the battery ground cable

    Refer to: SPECIFICATIONS

scientia non olet · About LEMON Manuals