Removal And Installation: Installation

WARNING: This page is about a different variant/trim than selected.

CAUTION: Make sure that new nuts are installed.

NOTE: Install a new gasket.

Renew Part: Exhaust manifold nuts Quantity: 6 .

Renew Part: Exhaust manifold gasket Quantity: 1 .
NOTE: Tighten the bolts in the indicated sequence.

Fig 1: Exhaust Manifold Bolts Tightening Sequence
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque Specification: 28 Nm
CAUTION: Install new studs.

NOTE: Install a new gasket.

Renew Part: Exhaust manifold cross-over pipe studs Quantity: 3 .

Torque Specification: 13 Nm

CAUTION: Make sure that new nuts are installed.
Renew Part: Exhaust manifold cross-over pipe nuts Quantity: 3 .

Torque Specification: 24 Nm

WARNING: Make sure that new nuts are installed.

CAUTION: Make sure that the area around the component is clean and free of foreign material.
Renew Part: Turbocharger to exhaust manifold gasket Quantity: 1 .

Renew Part: Exhaust manifold to turbocharger nuts Quantity: 3 .

Torque Specification: 24 Nm
CAUTION: Apply Loctite 243 to the bolts.

NOTE: Make sure to clean the threads prior to installation.

Torque Specification: 32 Nm
NOTE: Tighten the bolts in the indicated sequence.

Fig 2: Exhaust Manifold Bolts Tightening Sequence
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque Specification: 28 Nm
Torque Specification: 10 Nm
CAUTION: Make sure that new sealing washers are installed.
Renew Part: Turbocharger oil feed pipe banjo bolt washers Quantity: 1 .

Renew Part: Turbocharger oil feed pipe banjo bolt Quantity: 1 .

Torque Specification: 30 Nm
Torque Specification: 11 Nm
Torque Specification: 9 Nm
NOTE: Install new gaskets.

Renew Part: Turbocharger oil return pipe gasket(s) Quantity: 1 .

Torque Specification: 9 Nm
NOTE: Install a new gasket.

Renew Part: Turbocharger oil return pipe gasket(s) Quantity: 1 .

Torque Specification: 9 Nm
Refer to: RIGHT EXHAUST GAS RECIRCULATION VALVE
Refer to: ENGINE OIL DRAINING AND FILLING