Removal And Installation: Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
Removal steps in this procedure may contain installation details.
- Remove the startup battery ground cable.
Refer to: SPECIFICATIONS
- Remove the generator.
Refer to: GENERATOR
-
NOTE:
- Make sure to clean the threads prior to installation.
- Right hand drive only.
Discard the bolt.
-
NOTE: Left-hand shown, right-hand similar.
-
CAUTION:
- Support the engine on a jack. The angle may need to be adjusted during this procedure.
- Use a wooden block to protect the oil pan when supporting the engine.
Using a suitable hydraulic jack, raise and support the engine.